LT/HT Panel And Cable-Work

Bringing electrical power into a large building or industrial site, and distributing it safely, is specialist work. Aeropack Infra undertakes complete LT (low-tension) and HT (high-tension) panel and cable work — from high-voltage incoming lines and transformers right down to the low-voltage distribution that feeds your equipment. With qualified engineers and decades of field experience since 1984, we deliver power infrastructure that is safe, compliant and built to last.

High-tension systems operate at voltages such as 11kV and 33kV and require careful design, the right switchgear and strict adherence to safety practice. Transformers step that voltage down to usable low-tension levels, and LT panels then distribute it to the building's circuits. Getting this chain right — correctly rated, properly protected and neatly installed — is essential for both safety and reliability.

Scope of our work

• HT lines, switchgear and terminations (11kV / 33kV class)
• Transformer installation and associated works
• LT distribution panels and main panels
• HT and LT cable laying, jointing and termination
• Power and motor control centre panels
• Protection, metering and earthing coordination
• Testing, commissioning and documentation
• Maintenance and fault attendance

Panels built for the job

We supply and install LT and HT panels rated and configured for your actual loads, with the protection devices, metering and controls your operation needs. Good panel work is about more than buying a box — it is about correct sizing, sensible layout, clear labelling and protection settings that coordinate properly so that a fault trips the nearest device, not the whole installation.

Cable work done right

Cables carrying high power must be laid, supported, jointed and terminated correctly to avoid hot spots, insulation failure and dangerous faults. We route cables on proper supports, make terminations and joints to standard, and test before energising. The result is a distribution system that runs cool, stays reliable and is safe to maintain.

Safe, compliant, supported

From design and approvals through installation, testing and commissioning, we take responsibility for the whole electrical backbone — and we remain available for maintenance and rapid fault attendance afterwards. If your project involves HT supply, transformers or substantial LT distribution, talk to our engineers early so the power infrastructure is designed right from the start.

From high voltage to usable power

Bringing power into a large site involves a careful chain: high-tension supply and switchgear, transformers that step the voltage down, and low-tension distribution that finally feeds the building's circuits. Each link must be correctly rated, properly protected and installed to standard, because this is the part of the installation where mistakes are most dangerous and most expensive. Our qualified engineers design and execute this whole chain so that power arrives safely and reliably where it is needed.

Cables that run cool and safe

High-current HT and LT cables must be laid, supported, jointed and terminated correctly to avoid hot spots, insulation failure and dangerous faults. We route cables on proper supports, make terminations and joints to standard, and test rigorously before energising. Done properly, the distribution runs cool, stays reliable and is safe to maintain for the life of the installation.

Tested, commissioned and supported

Because the consequences of getting HT and LT work wrong are so serious, we test and commission thoroughly and document the installation for your records. We remain available afterwards for maintenance and rapid fault attendance, because a power backbone of this importance deserves a partner who will still be there when you need them.